Qlogic SANsurfer iSCSI HBA Manager Uživatelská příručka stáhnout pdf (Strana 111)

5 – Non-Interactive Mode Commands

Non-interactive Commands

SN0054621-00 E 5-27

-rdh

(Port Restore Factory Defaults)

Type the following command to restore the specified HBA port’s settings to their

factory defaults:

-rdh <hba_port_inst> [A] [F N I T C V]

Where:

If you want to restore all areas of the HBA port, either use the A parameter, or use

no parameter. Otherwise, specify which areas to restore. For example, the

following command restores the firmware and NVRAM to the factory defaults:

-rdh <hba_port_inst> F N

For information on the interactive version of this command, see “Port Restore

Factory Defaults (CLI Option -rdh)” on page 4-28.

NOTE:

The -rdh command is not supported in the QLA4010 HBA.

hba_port_inst = HBA port whose factory settings you want to restore.

A = Restores the factory settings for the entire HBA (firmware parame-

ters, network parameters, iSCSI name, targets, CHAP table,

NVARAM, and IPSec).

Issuing this command resets the HBA. If you use this option, no

others are necessary.

F = Restores firmware parameters to the factory default values.

Issuing this command resets the HBA.

N = Restores network parameters to the factory default values.

Issuing this command resets the HBA.

I = Restores the iSCSI name to the factory default value.

Issuing this command resets the HBA.

T = Restores the targets to the factory default values.

C = Restores the CHAP table to the factory default values.

V = Restores the NVRAM to the factory default values.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 183 184

Žádné komentáře

Qlogic SANsurfer iSCSI HBA Manager Uživatelská příručka Strana 111